Wonder Fissure: Usage Manual: Getting Started

How to use WONDER FISSURE: Getting Started

Temperature Check the material and water temperature
Selection Select appropriate grade of WONDER FISSURE
Hole Design Design the hole pattern according to the job site
Pre-drilling Drill holes in the material according to the hole design
Mixing Make the required quantity of WONDER FISSURE mixture
Filling Fill the pre-drilled holes with the WONDER FISSURE mixture
Cracking Wait for the material to develop cracks

WONDER FISSURE GRADE SELECTION

Always start by matching the temperature of the material to be cracked with the temperature range of the grade of WONDER FISSURE. Also, match the temperature of the water with the grade of WONDER FISSURE you are mixing. (Ref - Table 1)

Table 1 - WONDER FISSURE Grade Selection Chart

Grade of WONDER FISSURE Temp Of Material Temp Of Water
WONDER FISSURE CM - H 35 °C to 45°C below 45°C
WONDER FISSURE CM - A 25 °C to 35 °C below 35 °C
WONDER FISSURE CM - B 15°C to 25 °C below 25 °C
WONDER FISSURE CM - C 5 °C to 15°C below 15°C
WONDER FISSURE CM - D -5 °C to 5 °C below 5 °C

TEMPERATURE ESTIMATION


As shown in the figure on the right, place a thermometer in the bottom of the hole and leave it in place for 2-3 minutes. Then quickly pull out the thermometer and take a reading. Avoid taking temperature right after drilling since the temperature of the hole is higher because of friction heat.